Replacing a mirror is a habitation project.
Some motorcar manufacturers keep considered hectic driving conditions, crowded parking lots and narrow garages by installing break-away mirrors. Others, in head-to-head competition where every dollar counts, install sole morals mirrors. The second are inexpensive, and the enormous majority are replaced in aloof a sporadic minutes.
Instructions
1. Frank the motorcar door where the mirror is broken. Partially concealed by the door panel -- where the window frame attaches to the door -- a plastic, triangular include hides the bolts that attach the mirror. Remove the embrace. Some are held by push-in clips and are levered absent; some accept a unmarried screw holding them in abode, and others lift up and slide away. It is blessing to refer to the utility volume for the pattern lifetime repaired, otherwise duty carefully when removing the incorporate. When the comprehend is removed, a recessed access existence to the mirror mounting nuts is exposed, on the contrary it may be bottom line to remove foam insulation that prevents air intrusion. This Testament incorporate the attachment nuts.
2. Remove the nuts holding the mirror in corner. There are normally three inadequate nuts that are threaded to studs that are item of the mirror. These studs involve over mounting holes. Removing the nuts is all that is required to remove the mirror, on the contrary, provided the mirror is powered the electrical connector must extremely be disconnected. It is easily accessed and disconnected. When all three nuts are removed, the mirror Testament slightly Blop down--the studs Testament direct it in place--and it will not fall off and scratch the paint. The new mirror's studs will also hold the mirror in place. It is, though, easier to install the nuts if an assistant holds the mirror steady while threading them on the studs.
3. Install the new mirror. Be certain to use a gasket if required. The gasket prevents water from leaking into the door. Do not over-tighten the nuts and cause the studs to pull out of the mirror's plastic stud mounts. Plug the power connection in and test the new mirror motor. Replace the insulation into the access hole, and install the decorative cover. Pay attention to the old mirror and make sure the new one is properly sealed. Align the studs and guide them through the mounting holes until the mirror is against the door frame. The studs will hold the mirror in place.
4. Install the mounting nuts onto the studs. Tighten them snugly. Some suppliers include new gaskets as part of the purchase, however, some suppliers do not. Reuse the old gasket if necessary. Not all mirrors have traditional gaskets and use types of Styrofoam that is applied in critical places.
