CD brakes on a vehicle hold three leading components. There are the brake CD, or rotor, which is mounted to the turn hub; the brake caliper, which is mounted onto the rotor; and the brake pads, which are within the caliper. Brake pads demand to be replaced every 60,000 miles or so. Moreover, the brake rotor should accept a smooth Stop, and should be replaced provided there are any inmost grooves that cannot be machined or finished off. To install contemporary rotors and brakes, acquisition outside the vastness and type of rotors, brakes and mounting bolts in the van's guidebook.
Instructions
1. Adoption jack stands to lift the unabridged foot (front or rear) of the vehicle. Always install brakes in pairs; so you'll be replacing the rotors and brakes on the go and left sides.
Fasten the rotor in compass by tightening the retaining screw that goes into the minor mounting gap on the CD.3. Connect the brake caliper mount to the rotor. Border up the mounting holes on the caliper mount with the holes on the mounting bracket on the trundle hub meeting.2. Incorporate the brake rotor (CD) onto the revolve hub. Generate certain the rotor is the fair immensity by comparing it to the mature rotor.
Contain the mounting bolts into the holes, and tighten them with a wrench.
4. Install the brake pads onto the caliper mount. Each side of the rotor has one set of pads, and they are held in place with shims and retaining clips that fit within the mount. Apply a nonsqueal compound to the backing plates on the shims, and make sure the pads face the rotors.
5. Attach the brake caliper to its mount, and tighten its bolts that fasten it to the mount. Use the banjo bolt to associate the brake hose to the caliper.
6. After installing the caliper, bleed the brake system to purge it of air. Open the bleeder screw on the caliper, and have a helper press on the brake pedal until all the air escapes. Connect a clear rubber hose to the bleeder valve, and stick the other end into a container of brake fluid to help the process.
7. Attach the wheels to the hub, and tighten the lug nuts before lowering the vehicle.
