The Mercury Villager was manufactured and sold for nine dotage (1993-2002) by the Ford Engine Firm. Maneuver to the front of the automobile.2. Lift the hood and remove the crackerjack cylinder cap, which is located on the hold water side of the engine, near the firewall that separates the engine compartment and the inner cabin of the Villager. Remove some of the brake fluid from the reservoir (enclosing half of the vat) with a turkey baster or syringe.
Instructions
1. Grassland the Villager on a Apartment lodgings surface and operate the parking brake. Turn off the engine and pull the hood Proceeds lever. The 1993 example, and all other models of the headmost lifetime of Villagers, were equipped with front anti-lock CD brakes. The front brakes on the Villager (and all other vans and minivans) bear a bigger engagement of stopping the vehicle during braking. Ford recommends replacing the brake pads every 35,000 miles; on the contrary, the lifespan of the brake pads can vary based on the driving habits of the owner. Peep the pads regularly and alternate them and any other components of the braking method constitute to be in disrepair.
Accommodation a shop rag over the masterly cylinder container to grasp debris from the fluid.
3. Loosen the lug nuts on all of the wheels related to the brake pads you Testament be changing. Turn Everyone lug aficionado one quarter turn with the lug wrench to tear the seal.
4. Lift the machine with the jack and put jack stands under the Villager's axles for block.
5. Remove the lugs and hire off the wheels.
6. Remove the backside of the two caliper pins with a T-40 Torx wrench. Both pins are located on the back panel of the caliper, near the limit farthest from the brake rotor.
7. Rotate the caliper upward and outside from the caliper bracket and brake pads.
8. Remove the two brake pads from the sides of the rotor. The pads rest in the slots of the caliper bracket. Benefit a Apartment lodgings screwdriver to pry the pads complimentary from the bracket.
9. Look the rotor and bracket for damage and interchange either or both components, provided expedient.
10. Manipulate anti-squeal brake grease to the backs of the inexperienced brake pads. Slide the pads into the slots on the bracket.
11. Squeeze the caliper piston into the side of the caliper with a pair of channel lock pliers or a C-clamp. Remove the pliers or clamp once the piston is fully opened.
12. Rotate the caliper back around the new pads and caliper bracket. Replace the caliper pin and screw it in with the Torx wrench.
13. Replace the wheel onto the lug bolts and screw on the lug nuts.
14. Lift the Villager with the jack and remove the jack stands. Lower the vehicle back to the ground and tighten the lug nuts.
15. Repeat the process for any additional sets of brake pads you need to replace.
16. Return to the inside of the vehicle. Start the engine and press the brake pedal repeatedly until the pedal response returns to normal. Move to the engine compartment.
17.Remove the shop rag and place a funnel into the master cylinder reservoir. Pour the brake fluid into the container until the reservoir is full.
18. Remove the funnel and replace the master cylinder cap. Close the Villager's hood.
