Replacing a catalytic converter is expensive, on the other hand it is largely so on the Kia Spectra. The discernment is the converter is apportionment of the exhaust manifold, and the replacement unit is sold as a intact meeting. The trend among manufacturers is to city the converter as speedy to the engine as potential since converters sole duty when they are burning. The Spectra converter is easily accessible, now ultimate the exhaust heat shield, and visible as soon as the hood is opened.
Instructions
1. Jack up the front of the automobile and city jack stands under the lower domination arms. Lower the vehivle and cause undeniable it is steady. Spray aerosol lubrication on the front muffler mounting bolts. The front two bolts attach directly to the catalytic converter. Remove the front and rear bolts, unplug the front oxygen sensor and remove the muffler by levering off the mounting rubber.
2. If there are none, jack up the car and remove the jack stands. Lower the car and perform a test drive. Spray a small amount of lubricant on each nut and wait 10 minutes.
3. Remove the eight nuts from the studs that hold the manifold in place. Remove the manifold and converter assembly and set it aside. Install the new converter and manifold by sliding the manifold flange over the studs and installing the nuts. Snug the nuts down tightly and from underneath the car, install new gaskets along with the front muffler. Tighten the four attachment bolts and use a screwdriver to lever the mounting rubber back into place. Plug in the oxygen sensor.
4. Start the car and listen for exhaust leaks. Raise the hood of the car and remove five bolts holding the the engine cover in place and remove the cover. Remove the four bolts that hold the exhaust manifold heat shield in place. There are eight nuts that attach the exhaust manifold and catalytic converter to the engine.
