Transmission fluid not solitary allows the transmission to alter gears, however besides to prevent the transmission from overheating. Moreover, the fluid acts as a lubricant to prolong the energy of the transmission's internal components. As the fluid circulates over the transmission, it gradually increases in temperature. To frigid the transmission fluid, the fluid is routed to the radiator at the front of the vehicle via two cooler lines. If the transmission is to be removed or the transmission cooler lines are to be replaced, the beginning course in either advance is to remove the cooler lines.
Instructions
1. Lift the front of the vehicle with a floor jack, then backing the weight of the vehicle with two jack stands positioned underneath the frame.
2. Lift the rear of the vehicle under the differential with a floor jack, then collar the weight of the vehicle with one jack stand positioned under Everyone axle at the differential.
3. Bleed the transmission fluid from the backside of the transmission at the transmission's pan. Many pans hold a filter plug that can simply be removed with a wrench. Pans that bring about not characteristic a remove plug must be removed. To remove the pan, loosen the bolts that secure the pan to the backside of the transmission, then cover the blade of a flathead screwdriver between the pan and the transmission. Twist the screwdriver to crack the pan's gasket from the transmission. Custom the wrench to loosen the nut located carry on of each line, then pull the line away from the transmission to remove it.6. Remove the two transmission cooler lines from the bottom of the radiator. These two lines can be accessed either from underneath the hood or underneath the vehicle.
5. Remove the two transmission cooler lines from the side of the transmission with a glowing devotee wrench. To practice the wrench, slide the accessible bound of the wrench over the cooler path, then slide the wrench down the wrinkle until it reaches the aficionado used to secure the column to the transmission. Once the transmission fluid has stopped draining, remove the pan's bolts to remove the pan.4. Ajar the hood and bonanza the two transmission cooler lines, which edge to the backside of the radiator. Hint both lines underneath the vehicle to the transmission.
Use the flare nut wrench to remove the lines in the same manner used to remove the lines from the transmission.
7. Slide both transmission cooler lines away from the vehicle, pulling each line from the transmission rather than the radiator to complete the removal process.
