On many vehicles equipped with a rear window defogger, electricity flows buttoned up meager, brown grids mounted on the inside of your rear window, heating the existence Sufficiently To cleanse up any fog or frost. Provided your defogger is malfunctioning and exclusive partially clears the window, you may hog damaged or broken grids, which may not avow ongoing to flow former the damaged earth. Permatex manufactures a implements to repair the broken grids and restore your rear defogger to its abundant efficiency.
Instructions
1.5. Look through the repaired area from inside the vehicle. Apply additional coats of fluid to the stencil if you can see light through the repair. Continue applying coats and allowing them to dry until the repair is solid and no light is visible through it.
Peel off the protective backing from the stencil if with the instruments. Position the stencil slightly over the damaged sphere, ensuring the manage field in the stencil is directly over Everyone side of the damaged grid. Press the stencil against the glass. Rub down the stencil with your fingers to remove any air bubbles and to effect it is securely adhered to the glass.
3. Shake the container of defogger repair fluid to alloy it thoroughly. Remove the cap and stir any lumps in the fluid with a Toothbrush, whether fundamental.
4. Operate a coat of defogger repair fluid to the manage globe of the stencil with the mini brush if with the utensils, ensuring you overlap both sides onto the undamaged areas of the grid. Permit the fluid to dry until it does not quality cheesy to the touch. Use two else coats in the identical fashion.
Turn off the authority switch for the rear defogger. Disinfected the universe of the inside of the rear window in the vicinity of the broken grid of the defogger with an alcohol-saturated cloth, which may be included with your defogger repair implements.2.
6. Peel the stencil from the rear window 30 minutes after the last coat of fluid has been allowed to dry.
7. Repair additional broken grids in the defogger in the same manner.
8. Turn on the defogger after the repair fluid has cured. Set a multimeter to a resistance-measuring mode. Place the multimeter probes on the undamaged portion of the grid on either side of the repaired area. If the reading on the meter is more the zero ohms, apply additional coats of defogger repair fluid, then re-test grid with the multimeter.
