Modify a 2000 Dodge Intrepid Alternator
A evil alternator can author stalls, dead batteries or yet damage the battery of your machine. Whether your 2000 Dodge Intrepid has the 2.7L engine, expect to spend approximately an age replacing the alternator owing to of the commitment to office under the van. In 3.2L and 3.5L models, the replacement Testament matchless proceeds approximately half an generation. Many alternator shops can repair your removed alternator or consign you a reduction on the replacement provided you Commerce in your wick baggage.
Instructions
2.7L Engine
1.3. Unbolt and remove the plastic comprehend from the backside of the engine.4.
Disconnect the denial (brunet) cable from the battery, then remove the firm (carmine).2. Uplift the front aim of the van and compass it securely on jack stands. The lift points are bona fide far under the edge--refer to your vehicle's owner's volume for an illustration.
Unbolt the transmission cooler and modification it to the side, on the other hand cause not disconnect the hoses. The cooler looks alike a small radiator underneath your car, connected by hoses to the transmission.
5. Unbolt and remove the support for the radiator, replacing it with a jack stand.
6. Loosen the T-bolt that adjusts the alternator, then loosen the pivot bolt. Do not remove them. This removes tension from the alternator belt. Remove the belt.
7. Disconnect the electrical connectors. The battery line is held in place with a nut. Remove the pivot bolt and alternator.
8. Install the replacement alternator. Installation is the reverse of removal. Torque the battery cable nut to 90 in-lbs. (7.5 ft-lbs.) and the pivot bolt to 40 ft-lbs.
3.2L and 3.5L Engines
9. Disconnect the negative (black) cable from the battery, then remove the positive (red). Unbolt and remove the upper support rail for the radiator.
10. Loosen the lower mounting bolt and pivot bolt on the alternator, but do not remove it. This relieves tension from the belt. Remove the belt.
11. Disconnect the electrical connectors. The battery line is connected with a nut.
12. Unbolt and remove the alternator. Install the replacement using the reverse procedure. Torque the battery cable nut to 85 in-lbs. (7 ft-lbs.) and the mounting and pivot bolts to 40 ft-lbs.
