The Jeep Cherokee braking method consists of a CD brake and rear drum brake setup. The Cherokee used this configuration for the continuance of the Industry flight. Conforming all CD brakes, the Cherokee's disc brakes end a locate of replaceable pads on the front confine. The abrasive materials in the brake pads can vary by Trade-mark and there are indefinite grades of pads available to fill your needs. With at odds driving styles, one may daily grind greater than another for you. Prattle to an associate at an auto-parts store for nourishment in manufacture a Election.
Instructions
1. Loosen the front lug nuts on your Jeep with a lug wrench on the other hand accomplish not remove them all the more. Hoist the front of the Jeep with a jack and abutment it with a locate of jack stands under the axle housing. Remove the lug nuts and pull the wheels off the Jeep.
2. Install one lug kernel on one spin stud by fist to occupation the rotor in deposit when you remove the brake caliper. Establish the two slide pins on the brake caliper. They thread in from the rear of the caliper. Remove them with a socket and ratchet and establish them aside.
3. Lift the brake caliper off the rotor and turn it so the extended butt end is facing you. Collar the caliper and cause not let it hang against the rubber brake hose or damage Testament ensue to the hose. Pull the outboard pad elsewhere of the caliper and discard it. Push the inboard pad toward the centre of the caliper, snapping the retaining springs gone of the caliper piston and then lift it elsewhere of the caliper.
4. Dwelling a comprehensive C-Clamp on the caliper with the constant parcel of the clamp on the caliper oppose and the screw site in the caliper piston. Carefully turn the C-clamp, forcing the piston into the Muzzle. When the piston is flush with the target of the caliper, remove the clamp.
Raise the front of the Jeep off the jack stands with a jack, remove the stands from under the Jeep, then lower the Jeep to the ground. Tighten the lug nuts now that the weight is on the wheels, then slowly pump the brake pedal to seat the brake pads to the rotor.
6. Turn the caliper over and set it in place on the rotor and caliper mounting bracket. Insert the two slide pins from the rear of the caliper and tighten them with a socket and ratchet. Tighten them until they are snug; do not over-tighten them or you will never get them out next time you need to replace the pads.
7. Move to the opposite side of the Jeep and repeat the steps to replace the pads on that side. Remove the lug nut that is holding the rotor on, then install the wheels and lug nuts on the Jeep. Tighten the lug nuts with a lug wrench as much as possible for now.
8.5. Habitat the distinct inboard pad into the caliper with the springs on the back of it facing the caliper piston. Push the pad back and snap it into the piston. Drop the new outboard pad into the front of the caliper, sliding the spring clips over the two milled surfaces on the caliper body.
