Whether the alternator on your Cadillac goes outside, you'll compulsion to receive it constant quite quickly. Otherwise, your battery won't charge and the coming interval you oomph to begin the vehicle, you'll gem yourself stuck on the means. The billet itself isn't largely ball-buster, on the other hand it can obtain approximately an time to effect with the honorable tools. In this event, the project vehicle is a 2004 Cadillac Escalade, on the contrary the system is congruent for other vehicles.
Instructions
Set the replacement alternator in the engine bracket and bolt it in place, using the factory hardware and the 3/8-inch ratchet and socket.4. Use the 1/2-inch ratchet, extension and socket to move the tensioner again and set it over the alternator, then route the belt according to the diagram sticker on the core support of the vehicle. Unplug the wiring harness from the alternator at the duplicate duration.
2. Use the 1/2-inch ratchet, extension and socket on the tensioner pulley and pivot it to release the tension on the drive belt. Take the drive belt off of the alternator.
3. Unbolt the alternator from the engine brackets, using the 3/8-inch ratchet and socket. Pull out the alternator and set it to the side.1. Disconnect the actual terminal from the battery, using an open-end wrench. Then unbolt the battery cable from the alternator using a 3/8-inch ratchet and socket.
5. Reconnect the battery cable to the alternator and to the battery cable, using an open-end wrench. Then plug in the alternator wiring harness. Start the vehicle and let it run for 10 minutes, with your eye on the voltage gauge. If it stays steady at just under 14 volts, then the job was done correctly.
