Removing a motorcar's drive shaft is easier than you might expect. A unusual steps encompass procedures needed for most rear circle ride cars. Benefit the adjacent steps to receive finished the channels quickly and on to the later page of your project.
Instructions
1. Loosen nuts at the U-joint where the drive shaft connects to the yoke. Repeat at the other end.4.
Jack the car up to the desired work height. Put jack stands under the frame for extra precaution in the event that the floor jack fails.
3. Refer to your car's manufacturer's manual to locate the rear drive shaft. Cook positive automobile is on a Apartment lodgings surface, tires are blocked off and the emergency brake is engaged. This will prevent the car from moving during the procedure.2. Place the floor jack under the rear differential of the car.
Remove bolts. Carefully lower the drive shaft to the ground without disturbing the U-joint bearing caps.
5. Wrap electrical tape around the exposed caps on the U-joint to prevent them from falling off.
