The bleed screws for your brake lines are attached to the caliper extreme the machine turn.
Be prepared with Disinfected rags for brake fluid to leak elsewhere of the lines when disconnected.5. Put a ratchet over the bolt heads on the skilled cylinder. The skillful cylinder in the brake course releases brake fluid to the front caliper under vigour in aligning to block the van when you development on the brake pedal. You notice the skilled cylinder has failed when the brake pedal goes low to the floor when stepped on. There are two compel systems of the crackerjack cylinder: the salient and the secondary power systems.
Instructions
1. Lift the hood of the 2000 Dodge Neon and contemplation for the brake skilled cylinder at the top true side of the engine. Make the parts of the brake step: the brake master cylinder, the brake fluid cap, the brake lines and the brake fluid even sensor.
2. Extract the brake fluid from the reservoir. Remove the cap and, with a baster, suck elsewhere the brake fluid as still as practicable. Refill the reservoir with Fleck 3 brake fluid and levy the cap back on.
3. Pinch the safety clips on the brake fluid calm sensor connector with pliers and pull the electrical connector gone of the brake-cylinder meeting.
4. Place a 5-point open-end wrench on the brake fluid contour where it connects to the crackerjack cylinder. Turn the wrench counterclockwise and loosen the becoming. Remove all the brake lines the alike action.The 2000 Dodge Neon is a DaimlerChrysler vehicle with altitudinous performance. It is a mid-size sedan that is diverting to coerce, expressly provided you love the sound of an engine accelerating. The Neon has a hydraulic brake manner.
Twist the ratchet counterclockwise to loosen the bolts. Lift the masterly cylinder off the bolts and remove it from the engine field.
6. Install a contemporary master cylinder. Set the new master cylinder on the mount bolts and tighten. Reattach the brake lines, the fluid level sensor connector and refill the reservoir with DOT 3 brake fluid. Make sure the cap is secure on the reservoir.
7. Unscrew the 4 brake fluid bleeder screws on the brake caliper. Remove the wheel of the Neon to bleed the brake lines.
8. Ask a friend to press the brake pedal down to the floorboard while you tighten the brake bleeder screws. As your friend takes the pressure off the brake pedal, fluid will flow into the master cylinder. Repeat this process to remove all the air bubbles in the brake line. An air bubble makes the brake pedal drop when pressed.
9. Test the brake pedal by pumping 8 to 10 times once you think all the air is out of the lines. Refill the master cylinder with DOT 3 fluid. Put the tire back on the Neon and test drive the car by driving forward and stopping and then backing up and stopping.
