Everyone locate of lock cylinders requires its own establish of keys.
Replacing the material lock cylinder in your GMC Yukon Motor lorry can add additional security to the vehicle. This can incorporate replacing the lock cylinders in the doors or the one in the ignition cylinder. These want their own seperate methods, and you must bethink that changing the cylinder Testament depend upon replacing the decisive extremely. You Testament one shot necessitate one current cylinder to exchange the ignition switch, on the other hand you Testament essential two or else to exchange the cylinders for the doors.
Instructions
Ignition
1. Disconnect the Yukon's contrary battery cable by loosening the cable clamp peanut on the brunet cable with a wrench.
2. Unscrew the two screws at the backside location of the steering path comprehend, and seperate the line's two halves to remove them. Pull off the instrument Swarm bezel, and then unscrew and remove the knee bolster. Adjust certain the gear shift lever is in "Grassland."
3. Subsume the ignition indispensable into the lock cylinder, and turn it to the "Run" position. Push the retainer pin at the top of the cylinder's housing using a thin screwdriver or punch, and then pull out the key and cylinder.
4. Insert the replacement lock cylinder's own key into the cylinder, and install it into the housing, lining up the retainer with the retainer slot within the housing. Push in on the cylinder until it snaps into position.
5. Turn the cylinder into the "Off" position, and remove the key.
6. Reinstall all the trim panels, and then reconnect the battery cable.
Door
7. Raise the window all the way and remove the door's inner trim panel. Insert the replacement cylinder into the door, and push the retainer into place, then connect the link rod.11. Reinstall the outside door handle with its nuts and link rod.
9. Disconnect the link for the lock cylinder, push the cylinder's retainer off with a screwdriver, and withdraw the cylinder from the door.
10. Disconnect the window controls, pry out the door pull/armrest assemblies with a trim stick, remove the screws with a screwdriver, and pull the panel up and off the clips.8. Disconnect the link connecting the outside handle to the latch, and remove the outside handle's retaining nuts with a small wrench. Remove the handle.
