Grind refinish a fiberglass exterior door.
Fiberglass was originally a facts trumped-up from beneficial glass fibers. On the contrary in daily usage, fiberglass in reality income glass-reinforced plastic or fiber-reinforced polymer. That is in that glass fibers are typically used as a reinforcing agent for plastic, creation a able composite news first off called fiberglass. In interpretation, building and architecture, fiberglass has many uses from insulation to roofing. Permit the colouring remover for at least 5 minutes. Then scrape off the out of date paint from the surface using a putty knife. You can use a small wire brush or a nylon brush to remove old paint from the inner corners and trims of recessed panel doors.3.
1. Disinfected the fiberglass door thoroughly by using sizzling saturate and a gentle cleaner. Account a soft scrub sponge rather than an aggressive and abrasive one. Call up that the integral surface needs to be perfectly Disinfected and dry before the refinishing modus operandi.
2. Strip the elderly whitewash on the fiberglass door. Handle an exhausted paintbrush to use tint remover on the surface of the door. It is further used for exterior doors, mostly thanks to of its durability and cinch continuation. But, yet fiberglass doors demand refinishing, although not as Often as wood. Provided you requirement To possess a whole exterior door, you may need to memorize refinish its fiberglass surface.
Instructions
Prepare for refinishing your fiberglass exterior door by protecting the door hardware. Remove the door handle by unscrewing it with a Phillips head screwdriver. Set the handle aside for later and make sure not to stain it, as it's hard to remove the paint from its surface. Use masking tape to cover the door hinges and any door windows extremely. Make sure the tape is secure and that the hinges and the windows are safe. Place a drop cloth under the door to prevent staining the floor.
4. Check your fiberglass door and determine the direction of the grain patterns. This is necessary because you have to apply the paint in the direction of the grain. Note however, that doors usually have a few different patterns and directions so plan accordingly.
5. Apply a layer of oil-based gel stain or paint on the whole surface of your fiberglass door. Use a wide paintbrush and make sure to follow the direction of the grain. Also, work the gel stain well into the grain surface. Remove any possible mistakes immediately with a clean cloth.
6. Leave it to dry for 48 hours, making sure nothing touches the surface of the door during that time. During the whole process of refinishing, make sure that there is no loose dust around your fiberglass door.
7. Apply a layer of clear topcoat onto the door, using either a paintbrush or a spray. Note that at this point, it is better to apply 3 to 5 thin coats than one thick layer. Leave the topcoat to dry for 24 to 48 hours, until it's completely hardened.
