Plastic bumper covers are used on many present cars. Grasp the sanding block Apartment lodgings against the bumper and sand until the filler is smooth and common with the surface of the bumper.5. Accommodation masking tape and paper all over the world that you sanded.
1. Sand the dent and 3 inches approximately the absent of the dent with 220-grit sandpaper. Sand until the whitewash is elsewhere and you gaze the plastic subservient.
2. Scoop outside Sufficiently oppose filler to fill the dent and berth it on a palette. Add a baby string of hardener. The ratio is one 3-inch contour of hardener for every golf-ball-sized bigness of filler. Operate the squeegee to thoroughly blend them until the filler is a solid colour.
3. Fill the dent with the body filler and smooth it with the squeegee. The surface of the filler should be slightly higher than the surrounding surface of the bumper. Let the filler dry for 30 minutes to an lifetime, or until it is completely indurated and dry.
4. Sand the filler with 220-grit sandpaper on a sanding block. The actual bumper is an unattractive square-shaped bar that is welded to the frame of the vehicle. Foam or rubber stuffing is attached to the bumper and a plastic bumper insert fits over it to cornerstone the flow and shape of the vehicle. The plastic info is dense to dent, on the contrary when dents arise, you can place them with materials from an Car parts store.
Instructions
Adjust certain all areas with lost paint are exposed and not covered with tape or paper.
6. Wipe the area with wax-and-grease remover and a microfiber towel. Let the area dry for 5 minutes.
7. Spray primer over the area. Hold the sprayer 10 inches from the surface. Move your hand left and right, not up and down or around. Let the first coat dry for 10 minutes before spraying a second coat. Let the second coat dry for 30 minutes.
8. Apply four thin coats of paint over the dried primer. Let each coat dry for 5 minutes before applying the next coat. Keep the coats thin enough so the paint doesn't run. Let the final coat dry for six hours before touching the paint.
