Alternate the Stereo in a 1996 GMC Suburban
The 1996 GMC Suburban shares its dashboard meeting with other trucks and SUVs within Popular Motors. For all of the vehicles in this Sort, Emigration of the stereo requires a abundant Emigration of the sprint panels from the stereo to the border of the Chauffeur's side. Installing an aftermarket stereo Testament hurting for the inclusion of a wiring harness adapter and a faceplate adapter, providing a uniform platform on which to mount the advanced stereo.
The switch must be popped absent of the dash panel before the panel can be removed.4. Pull the sprint panel near the passenger side vent out from the dashboard. Gun between the sprint panel and the dashboard and fix the orange locking pins.
2. Grab the sprint panel above the Chauffeur's side vent and pull it out from the dashboard by handwriting.
3. Push the headlight switch box, located on the backside left corner of the sprint panel (condign to the left of the steering line) from the front of the panel concluded to the back of the panel.
Instructions
1. Lift the hood of the SUV. Disconnect the balky battery cable from the battery using a 10 millimetre wrench. Rest the cable gone from the battery until the installation is gross.Pull the pins and remove the dash panel from the dashboard.
5. Pull the stereo mounting levers on either side of the stereo to Proceeds the stereo, production it able to be pulled from the dashboard.
6. Slide the plant stereo absent from the dashboard. Disconnect the wiring to the back of the radio by ability.
7. Contain a faceplate adapter into the stereo mounting dock of the Suburban. Pull the stereo wiring nailed down the front of the faceplate adapter.
8. Connect the stereo wiring from the vehicle to a wiring harness adapter. Connect the wiring harness adapter leads to the aftermarket stereo. Slide the latest stereo into the interval if by the faceplate adapter.
9. Align the main dash panel with the dashboard and reconnect the orange locking pins. Place the bottom edge of the panel against the dashboard and replace the headlight switch into the opening on the lower left side of the panel.
10. Press the dash panel against the dashboard, re-engaging the clips that hold the panel in place.
11. Place the negative battery cable clamp around the negative battery lead. Tighten the clamp of the cable with a 10 millimeter wrench.
