The clutch slave cylinder on your Chevrolet S-10 is located underneath the Motor lorry. Lift up the S10 with a motorcar jack. Capitalization a socket wrench to remove the two bolts securing the hydraulic borderline to the slave cylinder and remove the hydraulic wrinkle. Repeat this mechanism with the hydraulic line connected to the master cylinder.
1. Disconnect the annulling cable from the battery with a socket wrench.
2. An critical Element of the S-10's hydraulic clutch course, the slave cylinder is crucial for safely operating your vehicle. It is connected to the out of the transmission and should be replaced these days provided begins to malfunction. Thankfully, replacing your S-10's clutch slave cylinder is a quite elementary procedure that should not proceeds you exceeding than half an date to perform.
Instructions
3. Use a socket wrench to uninstall the two bolts securing the slave cylinder to the S10. Pull the slave cylinder off the transmission and install a replacement slave cylinder.
4. Reattach the two bolts and reconnect both hydraulic lines. Lower the S10 and reconnect the negative cable to the battery.
