The Saturn Vue employs both front and rear circle hub bearing assemblies. These assemblies come from the foundry plenary with unserviceable bearings already pressed into the hub. They wish no lubrication owing to they are sealed units. Inside the meeting is Sufficiently lubricant to supply function to the bearing for a undeniable size of generation. Some bearings can spread 100,000 miles or and. Changing the front or rear hub bearing meeting in the Saturn Vue requires the identical procedure with a couple of subtle differences.
Instructions
1. Engage the parking brake after placing the Vue on a Apartment lodgings, paved surface.
2. Remove the hub cap or centre cap from the tire in wringer provided relevant.
3. Gash the lug nuts loose 1/8 of a turn counterclockwise with the lug wrench. Rupture the spindle seed loose one all-inclusive turn with the breaker bar and a 34-mm spindle kernel socket for a front bearing or a 30-mm spindle follower socket for a rear bearing.
4. Lift the Vue with a car jack and place a jack stand beneath the SUV to support it. Finish removing the lug nuts and then remove the wheel.
5. Locate the caliper bracket mounting bolts on the back side of the backing plate. Use the breaker bar and appropriate size socket to break them free and then switch to a ratchet to speed up the process.
6. Gently pry the caliper assembly off of the rotor using a small pry bar. Use a length of mechanic's wire or rope to bind it to the coil spring of the suspension to avoid it from dangling from the rubber brake hose.
7. Remove the rotor from the hub flange. Finish removing the spindle nut from the spindle with a ratchet and the appropriate socket.
8. Be sure to disconnect it from every retaining device along its length to the plug. A new wire and plug will come with the replacement bearing assembly.10.
9. Disconnect any ABS sensor wires connected to the hub bearing assembly. If you follow the wire (if applicable), you will find where it is plugged into the harness. Spray the front and rear hub flanges with lubricating spray on the front and rear where the bearing retaining bolts are located. The front Vue bearings employ three retaining bolts and the rear bearings use four. Allow the penetrating lubricant time to soak in.
Remove the hub bearing retaining bolts, breaking them free with the breaker bar first and then switching to the ratchet.
11. Use the hub puller (if necessary) to pry the hub bearing assembly from the hub.
12. Clean the mating surfaces of the hub and bearing assembly with emery cloth or sandpaper. You will need to manipulate the spindle of the drive shaft to clean the top of the hub surface.
13. Install the new bearing by reversing the steps. Use the torque wrench to tighten all bolts to the recommended torque specifications. You can find these in the owners manual or in a repair manual specified for the Saturn Vue. The parts store that sold you the wheel bearing assembly can look up these specs for you at no charge.
