2000 Ford F-150 V-6 Serpentine Cestuses Installation
The 2000 Ford F-150 V-6 engine has eight antithetic components that are powered by the serpentine cummerbund process (seven provided you posses the inventory replica without air conditioning). Everyone Element is turned by the girdle when the engine crankshaft spins. From date to clock, the serpentine zone needs to be replaced due to wear and tear and eventual breakage. Installing a modern band allows you to direct your engine running in top configuration and grip your F-150 on the means and away of the garage.
Instructions
1. For example, on the 4.2L engine, you need to rotate the tensioner counterclockwise to release the pressure on the tensioner. On the 4.6L engine, the tensioner must be turned clockwise. Hold the tensioner in place and use your other hand to leverage the belt over the pulley with the flat-head screwdriver. Release the tensioner carefully so that it slowly moves back into its original position. Touch to the diagram to establish the automatic tensioner pulley. Verify the routing road of the region over the components of the engine, as it can be slightly differential depending on which F-150 mould you get.
2. Route the sash on all sides of the assorted parts, birth with the crankshaft pulley. Postdate the directions on the routing diagram chart. Build positive that the notches on the serpentine belt straighten with the notches on the pulleys that have them. Some pulleys don't have notches and turn naturally when tension is applied to the belt via the automatic belt tensioner. Be prepared to work under the F-150 as well as from above the engine to route each pulley. Use a small piece of masking tape to hold each pulley in place once installed. Do the tensioner pulley last.
3. Attach the 1/2-inch socket to the end of the breaker bar ratchet. Attach the socket to the bolt protruding from the automatic belt tensioner. Rotate it in the direction indicated on the routing diagram. Lawns your vehicle in a Apartment lodgings spot and allot the parking brake. Cleared the hood of your Ford F-150 and establish the serpentine girdle routing chart, either on the underside of the hood or on the radiator shroud subsume. Disconnect the leads to the battery with the adjustable wrench and allot them to the side.
4. Remove the masking tape pieces from the pulleys and reconnect the leads to the battery. Start the engine and let it run for several minutes to allow the automatic belt tensioner a chance to adjust itself. Listen for sounds, such as slipping or flopping noises, which may indicate that the belt has been improperly installed and needs to be adjusted.
