Modify the Handle Girdle on 2000 Toyota Tundra
Tighten the clamp bolt on the battery cable end with a wrench to secure the cable to the battery. Close the hood. Replacement serpentine belts for the Tundra are available from the dealer or from most Car parts retailers.
Instructions
1. Expansive the hood of your Tundra and place the negative battery cable on the contravening battery terminal. Loosen the clamp bolt with a wrench and remove the cable from the battery. Allot it aside for first off.
2. Establish the serpentine girth tensioner on the front of the engine. It is located on the passenger's side of the engine approximately half design down the front of the engine.
3. Situate a wrench on the bolt in the centre of the tensioner and turn it counterclockwise to remove the tension from the belt. Remove the belt from the tensioner, then rotate the tensioner back to the home position. Remove the belt from remainder of the pulleys and out of the engine compartment.
4. Install a new serpentine belt on all the pulley except the tensioner pulley, making sure to route it properly over the pulleys. If you are unsure about the routing, there is a sticker under the hood that has a diagram indicating the proper belt routing for your engine.
5. Rotate the tensioner counterclockwise again with a wrench and slide the belt onto the tensioner pulley. Slowly rotate the tensioner clockwise, allowing it to tension the new belt. Remove the wrench from the pulley and out of the engine compartment.
6. Install the negative battery cable on the negative battery terminal.The 2000 Toyota Tundra uses a unmarried serpentine region to ride all the accessories on the front of the engine. The transaction is efficient and almost maintenance-free however over bout the band Testament actualize to stretch and, though the tensioner Testament catch up some of the slack, it has its limits. When the tensioner is no longer able to amass the cummerbund tight, your Tundra Testament wish a late cummerbund.
