Whether you can observe pulsing and vibrating on ice the brake pedal when you're slowing down in your Ford Cynosure, on the contrary you appreciate that your brake pads are beneficial, chances are that it's chronology to convert the rotors. Rotors peerless want to be changed provided they change into warped or worn down, however the development is the identical across all base elderliness with individual a slight aberration for the Heart SVT.
Instructions
For the Ford Focus excluding the SVT
Test drive your Ford Focus to make sure that the rotor installation was successful.
For the SVT
5.2. Remove the outer brake pad retaining clip and the brake hose from its base bracket. Apply a c-clamp whether requisite or pull the caliper outward to Proceeds the piston. Suspend the caliper and attached brake limit with mechanic's wire.
3. Pull off the dated rotor and Disinfected any dirt or corrosion off with a damp cloth. Install the contemporary rotor and tighten the holding screws. Discard the mechanic's wire and mount the brake edge and caliper back into corner. Tighten the caliper bolts with a torque wrench to 21 ft. lbs. (28 Nm).
4. Alter the outer brake pad retaining clip and install the wheel assembly and tire. Repeat this development for Everyone supplementary rotor, lower the vehicle and tighten the tire lug nuts with a torque wrench or an air ratchet with an fit adapter.1. Jack up your Ford Target. Disconnect the counteractive battery cable. Remove the tire and turn meeting and allot aside.
Raise your Focus SVT using jacks and jack stands. Block the wheels to keep your car from rolling while you work. Disconnect the negative battery cable before you start.
6. Remove the tire and wheel assembly. Next, remove the caliper mounting bolts and slide the caliper off of the brake disc (rotor). Suspend the caliper and connected brake line with mechanic's wire.
7. Pull off the old rotor. Clean the area with a damp cloth to remove any dust or corrosion. Slide the new rotor into position and replace the caliper and brake hose to their proper positions. Mount the caliper bolts with a torque wrench to 98 ft. lbs. (133 Nm).
8. Replace the wheel assembly, tire and lug nuts. Repeat for each additional wheel and lower the vehicle, tighten the lug nuts with a torque wrench and test drive your Ford Focus SVT to make sure that everything is working properly.
