Is the outer hold on your Jeep Wrangler broken? Possibly you blameless demand to add chrome or painted handles? Changing the handles is not tough, on the other hand it is a dwarf involved. You must disassemble the interior of the door to receive to the inner workings of the exercise. Provided you are changing to a painted arm or possibly a chrome bail from painted, it can absolutely exchange the overall appearance of your Jeep or add to the thesis you keep started.
Instructions
Tap the keeper pins down with a long-handled screwdriver until the tail of the keepers are two to three steps down. If they are not down far enough, they will not hold the handle tight and the assembly will rattle.9. Reconnect the inside lock knob on the handle to the latch rod very as the outside release handle to the latch rod.
2. Remove the clip that retains the rod connecting the knob to the lock mechanism, using a twosome of pliers. Conclude not lose the clip; it is immature, so asset a unharmed district to settle it.
3. Fix the two keeper pins on either side of the handle assembly, and remove them by driving them up from the backside. A flat-head screwdriver or analogous entity Testament labour fine for this. Save these pins, as you will reuse them to reassemble the door.
4. Disengage the latch release rod from the handle. Separate the handle from the door.
Installation
5. Attach the latch release rod to the door handle. Reinstall the small spring clip that you removed earlier.
6. Install the gasket and new handle into the door. Make sure you line the gasket up properly so that it seals to keep out air and water.
7. Slide the keeper pins back into the handle assembly from inside the door. They must slide in from the top of the assembly.
8.
Removal
1. Remove the inner door panel and the vapour barrier on the Jeep's door. Fabricate confident the window is in the up position so that you can access the rods and clips on the back of the handgrip.Replace the vapor barrier and door panel on the inside of the door.
