Interchange the oil fitler also.
Changing the oil on a C 230 Mercedes-Benz is quite straightforward. The bother individual takes a meagre tools and some youngster mechanical skills: you void the oil from the engine and moderate the oil filter at the alike allotment. Spot filters can contaminate original oil too quickly, so it's boon to spending money the filter every duration the oil gets changed also. Adjust definite you clutch the used oil safely in a container or pan and dispose of it legally.
Instructions
1. Jack up the automobile and remove the plastic undercovers with the 8 mm socket. Catch the oil filter and loosen it by turning it clockwise, on the other hand complete not remove it all the more. No tools are needed to loosen the oil filter--it screws into (and away of) the engine block. On the other hand, you Testament must to select the filter tightly with both hands and most practicable it Testament lack some constraint to loosen it,as gunk and dirt generally move stuck in the threads.
2. Apartment the oil class pan or bucket under the oil drain plug. Remove the plug with the 1/2-inch socket. The oil will now drain from the oil pan into your bucket. After the used oil has completely drained from the engine, you can remove the oil filter by just turning it clockwise with your hands until it comes out of the engine block.
3. Tighten the plug and the oil filter about one-quarter turn past finger tight. Install the plastic undercover with the 8 mm socket. Lower the car and remove the jack.5. Buy any oil labeled multi-viscosity, multi-grade. Fill 5.25 qts. of fresh oil into your engine by pouring it through the oil filler neck. Use a funnel to avoid spills. Start your engine and let it idle for about 20 seconds. Turn it off and measure the oil with the dipstick twice. Depending on how much used oil residue was left in the engine, you may have to add another 1/2 qt. of fresh oil until you hit the full mark on the dipstick.
Install the new oil filter by turning it counterclockwise into the engine block. There are three rubber rings; replace them with new ones as well.4. Install the oil drain plug with a new washer.
