The 2003 Nissan Maxima is equipped with disk brakes on all four wheels. The brakes attempt by utilizing a hydraulic piston to press two pads against a Apartment lodgings rotor, or disk. This causes friction, which in turn slows and eventually stops the motorcar. Whether air seeps into the hydraulic method's brake lines, the brakes Testament not supply properly. Air can enter the method during prolongation procedures that subsume removing brake components or when the fluid common is allowed to Blop as well low. Provided this happens, you Testament annex to bleed the air gone of the lines.
Instructions
1. Frank the hood and disconnect the balky battery cable. This is alone chief provided the van is equipped with antilock brakes. Disinfected the exterior of the proficient cylinder with rags to remove dirt and expansive the cap. Deposit a Disinfected rag over the top of the skilled cylinder to prevent contamination.
Use a wrench to open the bleed valve, allowing air to escape, and then close the valve. Repeat the pumping, opening and closing process until brake fluid flows out of the valve. Close the valve and remove the tube.
3. Attach the tubing to the bleeder valve, which is hovering on the inner side of the brake caliper. Corner the other end of the tube into a container.
4. Direct your assistant to slowly pump the brake pedal until it is hard and then hold it depressed.
5.2. Loosen the lug nuts on all four wheels and up thrust the front and rear of the vehicle, supporting Everyone side with two jack stands. Remove the lug nuts and proceeds off all four wheels.Provided you by oneself keep one jack stand, you can conclude one spin at a hour, starting with the right-rear trundle, then the left-front, the left-rear and the right-front.
Check the fluid level in the master cylinder. If necessary, add fluid to the "Full" mark.
6. Move to the left-front wheel and repeat Steps 3 through 5.
7. Move to the left-rear wheel and repeat Steps 3 through 5.
8. Move to the right-front wheel and repeat Steps 3 through 5.
9. Replace the wheels and lug nuts and lower the vehicle from the jack stands.Tighten the lug nuts. Check the fluid level in the master cylinder one last time and add fluid, if necessary. Close the cap on the master cylinder and reconnect the negative battery cable.
