The Honda Accord utilizes four brake discs (brake rotors) for braking. These rotors seldom obligation to be replaced, on the other hand whether they incline warped or worn down and can't be resurfaced, then it's day to swap them absent for latest. The measure for changing rotors is light and you can save lot of wealth by doing the labour yourself.
Instructions
1.3. Undo the caliper mounting bolts. Slide the caliper assembly off of the old rotor.
Bleed approximately half of the brake fluid from the crack cylinder to prevent overflow. Jack up your Honda with car jacks and jack stands. Block the wheels to keep your car from rolling while you work. Remove the first tire and wheel assembly and set it aside.
Pay for a latest place of rotors for your Honda Concur. Ideally, you should convert all four brake rotors at the twin interval, on the contrary you can dispose absent with changing ethical the front or rear extremity twosome at the twin continuance. Never alter decent one, as this causes uneven and unsafe braking.2. Hang the caliper from the car's undercarriage with mechanic's wire, being careful not to let the brake hose get disconnected.
4. Remove the holding screws on the rotor. Next, pull the old rotor off the studs and clean the hub and surrounding surfaces with a damp cloth.
5. Install the new rotor and fasten the holding screws. Discard the wire and slide the caliper and brake line back into position. Fasten the caliper mounting bolts with a torque wrench or an air ratchet with an appropriate adapter. Replace the wheel assembly and tire.
6. Repeat this process for each additional rotor. When you're done, lower your accord, tighten and torque the tire lug nuts. Then refill the master cylinder with new brake fluid.
7. Pump the brake until you get a firm pedal and road test your Honda Accord to make sure that the new rotor installation was successful.
