Install Struts on a 1996 Honda Civic
1. Up thrust the vehivle with the floor jack and buttress it on jack stands. Remove the tire and spin meeting, using the lug wrench.
The struts on a 1996 Honda Civic generally acquire a lifespan of 75,000 miles provided used under natural highway conditions. One message of the lifetime to alternate the struts is Exorbitant bouncing of the hood when the brakes are applied. Another communication is continual bouncing when travelling over Rugged roads.
Instructions
Lift the hood.2. Remove the pinch bolt located in the lower bite of the strut, using a socket and a wrench. Remove the three nuts that secure the top of the strut to the inner fender great. These nuts are located under the hood, on the fender wells. Employment a 13-mm socket to extract them. Lift the strut up slightly to remove it from its lower attachment aim and remove it from the machine.
3. Compress the spring as far as credible, until the top plate is no longer touching the spring, using the spring compressor. Install a hex socket into the top of the strut shaft to clench it while using a wrench to remove the retaining devotee.
4. Remove the top bearing plate and carefully remove the spring. Remove the rubber spring seat and install it on the advanced strut.
5. Install the spring on the advanced strut, manufacture persuaded that the backside cusp of the spring sits properly in the rubber spring seat. The depression could be seen in the rubber seat, and this is where the speck of the spring should sit. Install the top bearing plate, followed by the retaining peanut. Employ the hex-head socket again to accumulate the shaft from turning, and tighten the follower with a wrench.
6. Proceeds the spring compressor. Install the strut into the mounting point on the control arm, then insert the pinch bolt and tighten. Lift the strut and insert the three bearing plate studs through the fender well holes. Install the 13-mm nuts and tighten. Install the wheel and tire assembly, then lower the car.
