Your Toyota Camry is a trustworthy and stylish motorcar, and you pop to garner it up the bad you can. Equitable whereas a side view mirror breaks does not tight-fisted you accept to buy expensive parts and labour to reinstall one. You can invest in an aftermarket mirror of champion factor from online sellers on sites such as eBay that bad eye aloof prize the initial mirror and worth a fraction of what you'd invest in a just out one. Installing a original side glimpse mirror yourself is light.
Instructions
Install a Toyota Camry Side View Mirror
1. Roll down the window all the bag on the door on which you're replacing the side picture mirror.
2. Set the interior mirror moulding in the upper corner of the conduct window. It is triangular and may be melanoid or the equivalent colour as the interior panels.
3. Pry the triangular moulding off gently with the screwdriver. It's a snap-in-place moulding and simply needs to be pried off. At the backside of the moulding is a 1/4-inch lip that inserts into the window cavity. Pry it loose from the door, and lift the lip away of the window cavity.
4. Allot the wire harness. Gently pull the wire out of the middle hole in the door. Use the screwdriver to assist you in pressing in the lock clip to unplug the harness from the mirror wire.
5. Remove the three foam rubber plugs from the door.
6. Locate the nuts inside the door cavity behind the foam rubber plugs. Remove them with the ratchet, extension and socket. Hold the telescopic magnet alongside the socket so the nut does not fall into the door cavity.
Insert the new mirror and thread and tighten the nuts onto the mirror studs one at a time.9. Plug the mirror wire back into the wire harness, and tuck it back into the door cavity.10.
7. Remove the old mirror from the door. Most likely the old weather stripping will have sealed the mirror to the door and will require a little effort to remove, but don't overdo it and scratch the paint on the door.8.
Replace the foam rubber plugs.
11. Insert the interior molding lip into the window cavity, and press it against the door until it snaps into place.
