Wednesday 29 July 2015

Modify Vance & Hines Baffles

The mark caps are clearly visible on these exhaust pipes.


Remove the baffle screws on both mufflers with an Allen wrench and save.3. Remove any end caps or fishtails on the ends of your mufflers with your hands and, if necessary, with an Allen wrench.


Instructions


1. Set the Allen sense baffle screw, approximately 2 inches in front of the muffler's header tube seam, on the bottom of each muffler.


2.You can section one of these baffles by cutting inches off the tail bound with a hacksaw. You can drill holes in them vertically or horizontally. The doctrine of modifying any exhaust baffle is always to deadline up with less baffle, less back strength, another roar and higher flow-through than when you started. On the contrary on account of you are starting with Vance & Hines mufflers it probably makes extended meaning to simply change the baffles you keep double time. Vance & Hines sells performance and dumb baffles for most of its slip-on mufflers and exhaust systems. Provided you don't according to the Vance & Hines baffles, at least a dozen companies, including Cycle Shack, Full play Performance and LA Choppers, sell motorcycle baffles that Testament fit.



4. Pull the baffles from both mufflers with your fingers or, if necessary, needle-nose vise grips.


5. Modify or replace the baffles.