Thursday 30 July 2015

Replace Thermostat

Install a cutting edge thermostat to save resources on your pressure bills.


Provided you keep an ancient inefficient thermostat, assent to purchasing a original programmable thermostat. You could edge up saving hundreds of dollars a year. Nevertheless provided the wiring in your happening thermostat looks adore a jumbled mess, you might envisage you don't perceive Sufficiently to install a advanced thermostat. Distinct thermostats, though, come with widespread manuals that criterion you completed the wiring course. Replacing a thermostat is a current do-it-yourself elbow grease.


Instructions


1. Turn off the succession breaker to your air conditioning unit and furnace before working on the thermostat. Some AC units keep a seperate breaker equitable following to the unit; provided not, you Testament committal to turn it off at your leading breaker box.


2. Remove the face of your current thermostat. There should be several wires coming out of the wall and inserted into connectors on the thermostat. The connectors should have letters stamped on the plate. Wrap a small piece of masking tape on each wire and write the connector code letter on the tape so you can match the correct wire when installing the new thermostat.


3. Remove the wires from the old thermostat. You may need a small screwdriver to loosen the connection and pull the wire out. Do not let any wires fall back into the wall.


4. Remove the old thermostat from the wall. If it contains a mercury switch, do not throw it in the trash. You must call your waste management authority for instructions on dispose of the mercury. Unscrew and remove the old backing plate.


5. Hold your new thermostat backing plate up to the wall and pull the wires through it. Use a level to straighten the wall plate. Use a pencil to mark where the new screws will be inserted.


Turn on power at the circuit breaker.12. Set the temperature.



8. Hold the new backing plate up to the wall and use a drill or screwdriver to insert the screws through the backing plate. The backing plate should now be mounted firmly on the wall.


9. Connect the wires to the same letters on the new thermostat. For example, if the yellow wire previously went to "Y," hook up the yellow wire to "Y" on the new thermostat. There will be some kind of clamp or small screw to hold the wire in place.


10. Mount the front of the thermostat to the wall plate.


11.6. Drill pilot holes into the drywall. Your new thermostat should come with screws and anchors, and the manual will tell you the size of the pilot hole to drill.7. Insert the anchors into the drywall. You may need to tap them with a hammer to push them all the way in, but be careful not to damage the drywall.