Dodge trucks applicability Torx screws for many Car repairs.
Nix ruins the interior appearance of a Dodge truck also than a sagging or torn headliner. The smallest tear can mature a large-scale rip in petty age as gravity Testament naturally pull the headliner off the headliner board once the material begins to hang down. Many Motor lorry owners Testament invest in spray headliner adhesive and one's darnedest to allot the headliner while it is much in apartment. Spray the board with adhesive spray and carefully place the new headliner in position. Peel the liner up and reapply it should any wrinkles or bubbles appear. The new liner should lay perfectly smooth.
Cause a Phillips or Torx screwdriver to remove the screws holding all the trim, dome flashing frames, sun visors, seat cummerbund brackets and anything else that may be attached to the ceiling of the Motor lorry in habitat and remove the items. Provided the screw is not easily seen, peep for a dwarf plug inset in the tool; pry the plug gone of habitat to disclose the buried screw.
2. Remove the door display trim by pulling it absent of abode, inauguration at the rear of the one lot trim -- toward the rear of the cab -- and working In relation to the front of the cab. Pulling Testament slide the plastic inserts attached to the trim absent of the metal clips attached to the door advise that are holding the trim in place. Remove the trim from the cab. Make sure to do this on the passenger and driver's side of the cab.
3. Guide the headliner board as it drops out of place so it falls at an angle and can be removed through the passenger side door. Do not attempt to remove it through the driver's side door as the steering column will block the way.
4. Lay the board down on a flat area and remove the old headliner. Peel the headliner off the board slowly while using a soft toothbrush to loosen the adhesive as it comes free.
5. Scrub the board clean of all old adhesive using an old toothbrush.
6. Fix any broken parts of the board by using duct tape to reform the area, hold the broken piece in place or cover any holes.
7. Unwrap the new headliner material and orient the roll on the board so the preformed openings for the dome light and other special forms will fall in the right position when laid in place.
8. This Testament not profession as the data must be formed smoothly to the board to extreme in congenial example. To repair the headliner in a Dodge Motor lorry, it is obligatory to remove the headliner board from the vehicle anterior.
Instructions
1.9. Put the headliner back into the vehicle. Replace any dome lights or visors first before moving onto the trim as they are easier to install and will hold the liner in place while remainder of the trim and accessories are installed.
