Remove the Starter on a 1990 Toyota Corolla
Before removing the starter on a 1990 Toyota Corolla, research to compose positive that the starter is at misapprehension and not the wiring. Research for battery voltage at the extensive wire attached to the back of the starter. Whether battery voltage is not demonstrate, the battery is at flaw. The little wire attached to the back is the ignition switch wire. This is the wire that actuates the starter every day the major is turned to the foundation position. Accept a helper turn the answer to the inception position and research for battery voltage on the inadequate wire. Provided battery voltage is not even now, the ignition switch succession is at misconception. If voltage is present, the starter is bad.
Instructions
1.3. Remove the large nut on the back of the starter, using a wrench. The large nut secures the battery plus wire. Remove the wire.
Disconnect the negative terminal on the battery with the use of a wrench.2. Disconnect the small 16-gauge wire on the rear of the starter by simply pulling it off. It is attached with a spade terminal.
4. Remove the two bolts securing the starter to the transmission, using the appropriate socket and ratchet. Remove the starter from the car.
