The 2000 Chevrolet Corvette is cut of the C5 or fifth-generation mannequin produced from 1997 to 2004. The C5 representation is equipped with the compelling LS1 V8 engine. The 2000 Corvette engine is rated at 345 horsepower. The automobile is 179.7 inches extensive, 73.6 inches Broad and weighs 3,300 lbs. The impel heighth can be adjusted on the principles suspension process by changing the position of four reconciliation bolts.
Instructions
1. Lawns the motorcar on a equable, Apartment lodgings surface. End a jack to hoist the rear of the van and bed the weight with jack stands for safety. Remove the rear revolve from the motorcar to accretion access to the accustoming world.
Search for the ride height adjustment bolts. The bolts are in front of the shock absorbers. Use a 10mm socket to adjust the bolt. Turning counterclockwise lowers the car and turning clockwise will raise it.6. Remove the jack stands and lower the car. Measure the distance from the ground to the top of the fender. Repeat the process for other side until the measurement is matched
Remove the jack stands and lower the car. Measure the distance from the ground to the top of the fender. Repeat the process for other side until the measurement is matched.
4. Jack the front of the car and support with jack stands. Remove the front tire for easier access.
5.2. Search for the rear assimilation bolt ultimate of the suspension traverse spring. Place the attitude of the bolt and using an 18mm socket wrench, turn the bolt clockwise to lower the motorcar or counterclockwise to raise it. Restrict the top nut from spinning with the bolt by holding a 13/16-inch open-end wrench on it.3.
7. Drive the car for 200 miles to settle the suspension. Measure the car again and make any adjustments.
