Oxy-Acetalyne torches desideratum careful setup before they can be used properly.
Oxy-Acetalyne torches are a guideline belongings for cutting or welding non-conductive metals. They combine acetalyne fuel with concentrated O2 to effect a white-hot flame capable of burning or cutting finished most metals; adjust the combine for lower heats for welding. Before you can practice an oxy-acetalyne torch, but, you must allot it up. This evolution includes attaching gauges and hoses to the fuel tanks, checking for leaks, and ensuring there is no dirt nor grit in the fuel lines. It is not a tough operation, on the other hand it can be time-consuming.
Instructions
1. Make safe the fuel cylinders are secured in apartment so they Testament not gratuity or fall over whether they are suddenly disturbed. Provided the fuel cylinders fall over while you are cutting, the weight could tomfool the cutting torch from your handwriting and basis Belongings damage or injury.
2. Stand off to the side of the acetalyne container and unlocked the valve of the vat honorable Sufficiently To admit a bitty hiss of Gauze to escape. This ensures the tanks are under coercion, and clears outside any dirt or grime that may get accumulated on the valve. Turn the valve off after two seconds.
3. Repeat the previous action for the O2 cistern.
4. Consult your manufacturer specification booklet to halt strength settings for the regulators. Place them accordingly.
5. Connect the fuel-gas regulator to the acetylene fuel cylinder and tighten it down with a wrench, then arrange the equivalent with the O2 regulator and the O2 container.
6. Open the valves on both tanks slowly. Open the acetalyne tank's valve only a half-turn, and open the oxygen valve all the way.
7. Connect the hoses to the regulators. The red hose will be attached to the acetalyne regulator, and the green hose to the oxygen regulator.
8. Purge the hoses of any grime or dirt by turning the flow screws in the regulator clockwise To admit the gas to flow through the regulator and into the hose. The red acetalyne fuel hose will connect to the needle-connector marked "fuel." The green oxygen hose will connect to the needle-connector marked "oxy."10. Ensure the valves on the torch are closed, then open the regulator screws to test the hoses for leaks. If no leaks are found, close the screws and then purge the hoses of gas by opening the valves on the cutting torch one at a time.
After five seconds, close the regulator valve by turning the screw counter-clockwise to close off the flow of gas. Do this for both tanks.9. Connect the hoses to the cutting torch.
11. Attach the appropriate cutting tip to the cutting torch, then consult the user documentation to determine what gas pressure is appropriate for that specific tip. Open the valves on the fuel and oxygen tanks until the regulators show the pressure indicated by the user documentation. Once you have done this, you are ready to light the torch and begin cutting or welding.
