A defective window regulator on your Town & Society motorcar Testament cast the window glass elsewhere of alignment, risking potential damage to the glass and other parts within the door. Provided you can't properly fit the glass back within the window, you must alternate the window regulator. The track the regulator rests in is within the door, so you must remove the interior door panel to disconnect the glass from the regulator and then the regulator from the door.
Instructions
1. Disconnect the automobile's counteractive battery cable, particularly whether it is equipped with bent locks and windows. Pry off the switch panel from the door with a diminutive, flat-blade effects and disconnect its electrical connector. Replace the screw heads on the guide rails and tighten the screws.6. Remove the tape on the glass carefully, lower it down into the door and screw it into place within the regulator. Replace the inner belt molding, then stick the water shield back in place.
Pry the fasteners off their clips by inserting a Emigration effects along the contour; set off at the backside of the panel and functioning your course all over. Lift and pull the panel gone, then disconnect all electrical connectors and the lock rod connecting the door practice.
3. Peel the drool shield carefully elsewhere from the door. Remove the inner belt molding by peeling the upper corner seals away and pulling the molding upward to disengage it from the door panel flange. Lower the window, loosen the screws holding the glass to the regulator plates, push the glass back up into the window frame and tape it in place.
4. Loosen the screws that hold the guide rails to the door panel and remove the screw heads from the keyhole slots in the panel. Detach the old regulator by lifting it up, slide it rearward and remove it through the door's access hole.
5. Insert the new regulator through the access hole in the door, slide it forward and push it down into place. Whether the automobile has a publication window Eccentric person, remove its retaining clip from at the end the Eccentric person with a hooked belongings and detach the Eccentric person knob.2. Remove the door's inner trim panel. Remove the fasteners within the door handle bezel, inner door accept and lower panel line.
