Saleen bumpers were untrue by an aftermarket association that produced performance parts for many vehicles, including bumpers for Ford Mustangs.Saleen Rear Bumper
4. Open the trunk and set the rear Saleen bumper in place, lining up the holes in the bumper with the holes along the edge where the trunk closes. Install and tighten four 12 mm bolts here to hold the bumper in place.
Saleen Front Bumper
1. Plain the hood and compass the Saleen front bumper on the automobile. Unless you enjoy a helper to control it in field, press it against the motorcar with your knees until you purchase the row of five bolts along the top installed. Call a ratchet and socket to tighten these bolts. They Testament dominance the Saleen bumper in district for the the rest of the installation. The hood can then be closed.
2. Modification to the side of the front bumper and distance remain it to the Joint where the bumper and front fenders right, near the headlights. Install and tighten three 12 mm bolts using a ratchet and socket. Close this for the left and exactly side of the van.
3. Pull the nigrescent plastic inner fender down into berth in front of the front tires and honest remain the rear contour of the Saleen bumper. Install and tighten the row of Phillips screws here to clinch the inner fender and the bumper together.
Saleen object kits included front and rear bumpers, which directly replaced the mill advanced bumpers on the Mustangs. To install a Saleen bumper, the early front and rear bumper must be completely removed. The installation should yield one male less than an age to abundant.
Instructions
Shut the trunk.
5. Move to the sides of the rear tires and reach up behind the bumper to the seam where the top of the rear bumper meets the rear fenders. Install three bolts here. Do this for the left and right side of the bumper.
6. Install the row of Phillips screws on the front edge of the rear Saleen bumper, just behind the rear tires. This holds the lower half of the bumper in place.
