CD brakes afford the chief stopping potentiality for a vehicle by squeezing brake pads against the brake rotors. The caliper pistons are forced closed by brake fluid when the brake pedal is depressed. Over day, and as a completion of appropriateness, the surface of the brake pads Testament wear thin, causing the brakes to operate at a consistent less than they were designed to function. Changing the brake pads at the comment of wear Testament enable the braking manner to operate properly when needed.
Ford brake pads accept wear indicators that explanation a "squeal" when the pads admit been worn to the mark that they depend upon replacement. Turn the steering wheel out from the side you are working on fundamental. For the left brake, turn the steering circle to the hold together.6. Remove the two caliper bolts with the 7-millimeter Allen wrench.
Loosen the lug nuts on the rotate with the socket of the tire iron.
2. Lift the Ford with the jack. Apartment the jack under the frame of the vehicle, not a fender or other less-secure thing of the vehicle.
3. Corner jack stands under the frame of the vehicle.
4. Remove the lug nuts and pull the spin from the rotate bolts.
5. You can include your Ford's brakes repaired by a know onions, or you can swap the gray-haired pads for virgin ones yourself.
Instructions
1.The caliper straddles the rotor. The caliper bolts are on the hold water side of the left brake; left side of the honorable brake.
7. Agape the brake fluid bleed valve with the 10-millimeter wrench. The valve is located near the upper constituent of the two caliper bolts. Two complete turns Testament adequately emptied the valve. Community a drip pan under the brake.
8. Remove the two brake pads clipped to the caliper sides. Capitalization a Apartment lodgings screwdriver to pry the metal clips on the back of the pads elsewhere from the caliper.
9. Settle the C-clamp over the caliper piston and the gone edge of the caliper. Screw the C-clamp to push the piston against the side of the caliper. The piston is the rubber-coated ring that extends from the inside of the caliper.
10. Apply brake grease to the area of the caliper piston now sitting flush with the side of the caliper.
11. Snap on the new brake pads to either side of the caliper. The thin metal clips will connect to the sides of the caliper by hand.
12. Return the caliper to the rotor. Replace the caliper bolts with the Allen wrench. Close the brake fluid bleed valve with the 10-millimeter wrench.
13. Turn the steering wheel so that the wheel is pointed forward. Place the wheel onto the wheel bolts. Screw on the lug nuts by hand.
14. Remove the jack stands and lower the Ford to the ground. Use the tire iron to tighten the lug nuts.
15. Press the brake pedal repeatedly. After pressing the pedal three times, the fluid that was displaced by opening the bleed valve and squeezing back the piston will be returned to the caliper.
