Distinct bumpers can dramatically doctor up the Mustang's appearance.
The 1965 Ford Mustang featured a span of one-piece, metal bumpers. Unlike contemporary vehicles that posses bumpers that can withstand kid bumps without sustaining damage, the '65 Mustang's bumpers Testament dent permanently. Over epoch, the chrome Stop tends to wear and rust bubbles growing underneath the Stop are not meagre. Happily, reproduction bumpers are gladly available from classic Mustang parts dealers and installation is quite straightforward.
Instructions
Front Bumper
1. Remove the two bracket bolts on Everyone location of the bumper with an open-end wrench. Everyone bolt is secured with a unmarried peanut that must be accessed from inside of the turn right. Remove the nuts and pull the bolts away of the front of the bumper.
2. Remove the two bracket bolts from brisk to the centre of the bumper with an open-end wrench. The bolts are secured in the equivalent step as the site brackets and must besides be removed from inside of the spin right. Remove the nuts and pull the bolts absent of the front of the bumper.
3. Open the trunk to access the bumper's four retaining bolts, located underneath the interior-side of the taillight panel.8. Remove the bumper's four retaining bolts with a socket wrench to release the bumper.
Install the two bracket bolts from rapid to the center of the bumper. Insert the bolts through the front of the fender, then install and tighten the two nuts to secure the bumper to its two brackets.
6. Install and tighten the two end bracket bolts in the same manner used to install the center bracket bolts.
Rear Bumper
7. Lift the bumper off the Mustang.4. Position the latest bumper onto the front of the van.5.
9. Position the new bumper onto the back of the Mustang.
10. Install and tighten the bumper's four retaining bolts with a socket wrench to secure the bumper in place.
