The door panels of your 2008 Honda Civic subsume the speakers, window regulators, absent door stem bolts, door locks, window controls, keyless entry controls, accent lights and side glimpse mirrors. Provided any of these parts must to be replaced or upgraded, the door panels must be removed. Spring from the steps below and you can easily remove the panels on your Honda Civic with two screwdrivers.
Instructions
1. Go around the outer edges of the panel and pry up with your hands to loosen any remaining clips until they pop. They will remain in the door panel and can simply be pushed back into place when installing the panel later.4. Pull up on the door panel to unhook it from the top of the door.
2. Manipulate the Apartment lodgings tendency screwdriver to gently pry up on the back of the armrest. Once pried up, the armrest can be pulled up and absent from the door. There are many wiring connectors endure the armrest, on the contrary allowance them connected and authorize the armrest to hang down. There is one added screw against the door panel that can be seen once the armrest is pulled absent. Remove it with a Phillips head screwdriver.
3. Grab the opening where the armrest was and gently pull the door panel away from the door to loosen the clips holding the panel in place. Expanded the door completely. Pull the interior door helve back to access the plastic access door. Handle a Apartment lodgings tendency screwdriver inserted into the cramped opening to gently pry the access door off, revealing a screw and a atramentous plastic bolt. Remove the screw and press on the centre of the bolt with the screwdriver to pop it up then pull it absent.
Lift from the sides, not the bottom, so that the panel doesn't bend in the middle. Pull the panel away from the door then look behind it and disconnect the large wiring connector that leads to the connectors at the armrest.
