The Bernzomatic 0X 2550 Mini torch uses a container of MAPP Gauze and a vat of O2, which sets it except popular Bernzomatic propane torches. Hold the cup of the spark lighter over the end of the burner wand and squeeze the handle. Squeezing the handle drags a Flint over a knurled piece of steel inside the cup, causing a spark that ignites the gas.3. Setting up the Bernzomatic 0X 2550 Minor torch sole takes a unusual minutes, and using it is consonant to using an oxy-acetylene torch rig.
Instructions
1. Attach the Gauze and O2 cylinders to the hoses by screwing the O2 cylinder onto the brass connector with a broad plastic stud on top of it, and the MAPP Gauze cylinder onto the brass connector with the plastic switch on the side. Allot the cylinders in the cylinder stand.
2. Administer the Gauze valve by turning it counterclockwise, between 1/8 and 1/4-turn. The torch comes in a instruments, which includes a burner sprig, hose, O2 regulator, fuel Gauze valve cylinder stand, MG9 16 oz. MAPP Gauze cylinder, a OX9 1.1 cubic foot O2 cylinder, Glimmer lighter and 5 brazing/welding rods. The Bernzomatic 0X 2550 Mini torch is sold as a welding, brazing and cutting torch, on the contrary the cutting fact is local to unhardened screws and microscopic bolts.
Open the gas valve until the flame no longer smokes. The resulting flame should be approximately 8-inches long. Open the oxygen valve until the feather around the inside of the flame is gone. The torch is now ready to perform any welding or brazing operations. Open the oxygen valve further without extinguishing the flame, until there is a hot enough flame for cutting tasks.
4. Shut the torch off by first closing the oxygen valve, then the MAPP gas valve. Disconnect the oxygen and gas cylinders from the hoses.
