The 1996 Chrysler Sebring Coupe utilizes an electrical Engine mounted to the engine block, to rotate the internal engine components when the engine is starting. Provided your motorcar is having occupation starting it could be a note that the starter needs replacement. While the Engine can be rebuilt, it is normally augmented bill able to alternate it with a distinct or remanufactured unit. Replacing a flaccid or defective starter Engine as soon as likely, could save you from fitting stranded.
Instructions
Four Cylinder Engines
1. Unhook the ground cable from the dissension battery assign. Eventuate by loosening the retaining bolt, using a wrench. Then seperate the cable from the bad terminal. Secure the cable so it cannot accidentally contact the battery.
2. Lift the front of the vehicle, using a floor jack. Back the vehicle using jack stands, before removing the jack.
13. Unscrew the nuts that secure the wiring harness to the starter solenoid, using a socket. Then pull the ring terminals off the solenoid.14.
Unhook the latches that secure the air filter top contain to the housing using your plam. Lift the include and the air filter out from the housing and remove them from the vehicle.
5. Unscrew the three bolts that secure the air filter housing representation to the chassis, using a socket. Lift the housing imitation gone of the engine bay.
6. Docket the wiring connected to the starter solenoid using duct tape and a felt gratuity marker.
7. Unscrew the nuts that secure the wiring harness to the starter solenoid, using a socket. Then pull the bell terminals off the solenoid.
8. Unscrew the two bolts that secure the starter Engine to the engine block, using a socket. Be persuaded to relieve the weight of the starter Engine with your labourer. Failure to accomplish so could strip the threads in the engine block. Remove the starter from the vehicle.
Six Cylinder Engines
9. Unhook the ground cable from the annulling battery proclaim. Commence by loosening the retaining bolt, using a wrench. Then seperate the cable from the absent terminal. Secure the cable so it cannot accidentally contact the battery.
10. Elevate the front of the vehicle, using a floor jack. Cornerstone the vehicle using jack stands, before removing the jack.
11. Unscrew the nuts and bolts that secure the exhaust tube to the exhaust manifolds. Lower the exhaust cylinder elsewhere from the engine but leave it connected to the catalytic converter. Support the weight of the pipe with wood blocks.
12. Label the wires connected to the starter solenoid using duct tape and a felt tip marker.
3. Loosen the hose clamp that connects the intake tract to the air filter housing using a socket. Then pull the tract off the housing.4.
Support the starter motor with your hand, while you unscrew the two bolts that secure the starter to the engine block. Then remove the starter from the vehicle.
