Building your own motorcycle exhaust is a project that takes some specialized tools, analogous a drainpipe bender, steel bender or welder and whether you thirst chrome, you own to cause the plating yourself, or grip your pipes to a metal shop where they Testament plate your pipes for a value. We Testament Stare at create the basic exhaust, on the other hand how you gloss it is up to you.
Instructions
1. Degree your bike from the head pipe connexion on the engine down to the foot pegs and then to the rear. Hold a brother mastery the template regular, and match it up various times. Be firm it works on both sides, provided you are building exhaust on both sides, owing to Everyone side of the bike is different.3. Figure out how many welds you will need to make, if any, then purchase the tubes for your exhaust.
Forthwith sketch absent a basic shape for your exhaust, using these measurements as a docent.2. Constitute a adequate dimensions template for your exhaust process on poster board, cardboard or plywood. Avail a hefty marker, and be besides precise with your measurements.
Buy them to the full length of the system, which you should have measured using a flexible tape measure, or tailor's measure. Measure the outside edge of each side for the most accurate measurement and take the larger one and add a foot or so.
4. Mark the location of each bend with a magic marker at the start of the bend. Allow for an extra half foot at the head pipe section so you can fit the tube in the bender.
5. Heat and bend the pipe at each mark. Make your bends fast but be accurate and do not over bend the pipe. You don't want To possess to bend the pipe backwards again.
6. Finish your bending, then attach the muffler. It should slide right on to your pipes.
7. Attach the hardware for the exhaust to your bike. This might have to be custom made as well. Then be sure the exhaust fits all the attachments, including the head pipes and rear braces.
8. Attach your new exhaust and pat yourself on the back. You made your own motorcycle exhaust.
