Brake drum
meeting
According to most vehicles, the brake shoes on a Chrysler Town & Nation office primarily with the parking brake, so they may not itch changing as ofttimes as brake pads. Whether the shoes act obligation to be replaced, you want to nickels the shoes on both rear wheels. This can be a tough means, as the brake drum meeting uses multiple springs and clips with the brake shoes.
Instructions
Accessing the Brake Shoes
1. Elevate the rear bound of the car and flotation it on jack stands, then remove the wheels. Loosening the turn lug nuts before raising the automobile Testament maintenance.
2. Slip the brake drum off. Whether it is stuck, turn the gear on the adjuster Harbour in the brake's backing plate with a screwdriver to retract the brake shoes.
3. Disinfected off the solid brake meeting with brake cleaner spray, placing a pan or other accept container below to clutch the dripping fluid.
Removing the Shoes
4. Detach the front brake shoe hold-down spring by urgent the retainer and turning it 90 degrees. This works choice with a defined Car parts store belongings designed for this chore.
5. Disconnect the upper transmit spring and the accustoming lever spring from the brake shoe using needle-nose pliers, then remove the upper spring, along with the tension clip and automatic adjuster, and the adaption lever and spring.
6.9. Detach the parking brake actuator plate from the dated front brake shoe and install it on the replacement, creation firm you properly seat the retaining clips.
Installation
8. Disinfected and lubricate the threads on the automatic adjuster screw. Bag a big temperature grease.
Disconnect the two send springs located at the backside of the shoes and remove the front brake shoe.7. Remove the actuating strut from the lower half of the brake meeting, remove the rear shoe hold-down spring and pin with the identical item as the front, and remove the rear shoe with the parking brake actuating lever.
10. Lubricate the contact surfaces of the brake meeting's backing plate with the high-temperature grease.
11. Connect the parking brake actuating lever to the brake cable and install the rear shoe to the backing plate, applying the hold-down pin and spring.
12. Reconnect the parking brake actuating strut, automatic adjuster, tension clip and upper return spring.
13. Install the new front brake shoe and mount it in place with its hold-down pin and spring. Attach the upper return spring, automatic adjustment lever, actuating spring and lower return springs with the pliers.
14. Connect the brake drum back onto the hub flange.
15. Adjust the brake shoes by inserting a screwdriver into the adjuster port--remove the rubber plug--and turning the adjuster gear. Adjust it until the shoes drag against a turning brake drum and then turn it the other way so the shoes just avoid dragging.
16. Reconnect the wheels and lower the car after changing the brakes on both sides.
