For a fuel injector to job properly, it needs to be able to turn the liquid fuel into an atomized vapour. Many inventors tried improving the modus operandi with resident results, however Last of all in 1982, the Bosch convention created a workable format and introduced its representation to the sphere. GM beginning introduced its legend of fuel injection in 1985, called it Tuned Harbour Injection(TPI) and levy it in many models, including the Corvette, Camaro and Trans Am.
Instructions
Verify that the cleaning tools hose is attached securely.3. Cut the cap off of the Gauze tank to keep the tank from being damaged by the high pressure created from the cleaning kit. Lay the other neb of the tubing into the Gauze cistern.
2. Attach the extreme of the fuel injector cleaning apparatus to the inlet valve of the fuel injector port by screwing the hose bib of the instruments onto the heel of the fuel injector Harbour.1. Establish the fuel borderline where it enters the engine compartment of your GM vehicle and disconnect the wrinkle from the fuel injectors. Settle one mark of the plastic fuel tubing over the fuel inlet contour and apply the screw clamp to secure the tubing to the border with a screwdriver.
Turn the ignition key to verify that fuel is not getting to the fuel injectors.
4. Check the owner's manual for your vehicle to determine what the maximum pressure reading should be for cleaning out your fuel injectors. Turn the valve on the fuel injector kit until the pressure reading reaches the maximum limit.
5. Turn the ignition key to start the engine and run the cleaning solution through the fuel injectors. Allow the engine to run for about five to 10 minutes and then turn the engine off.
6. Disconnect the cleaning kit hose from the fuel injector port and then remove the fuel line from the gas tank. Reconnect the vehicle fuel line to the inlet port of the fuel injectors and start the vehicle to test the results.
