Mounting running boards is a child's play development.
Installing running boards against the side of a vehivle is a light means. The running boards install against a panel located at the backside side of the automobile called a heater channel. The most earnest atom approximately installing the running boards is preparation. It is essential to the case of the machine that you prevent the spread of rust on the running boards and heater channel.
Instructions
1. Peep the example of the heater channel under the side of the machine where the running boards attach.5. Bolt the running boards to the holes in the heater channel. Tighten the bolts loosely.
You can as well spray the running boards themselves with the distemper provided desired. Acquiesce the emulsion to dry for two hours.
3. Spray the holes in the heater channel and the holes in the side of the running board with spray lubricant. Spray the bolts with lubricant very. This helps the running boards action smoothly against the side of the automobile.
4. Grip the running board against the side of the heater channel near the backside of the machine frame. Settle on your back under the automobile. Straighten the bolt holes in the running board with the holes in the heater channel.
Case for signs of rust. Provided rust exists, scrub the metal with a steel wool pad to remove most of the rust from the metal.2. Spray a rust preventative emulsion over the heater channel to prevent the metal from rusting again. Do not tighten the bolts all the way yet, because you may have to move the boards slightly to attach them to the fenders as well.
6. Bolt the top and bottom sides of the running board to the front and back fenders. You may have to drill a hole in the fenders for the bolts to feed through. If you have to drill a hole, mark the placement for the bolt with a marker, then use a drill to drill the hole through the fender.
