Whether you're replacing the rotors on your Dodge Dakota and require To possess them machined at the regional engine shop or Car parts store, why not close it yourself? Yet provided the Dakota is 4-wheel coerce, you can perform this employment with a hardly any tools.1. Grassland the Dodge Dakota on a Apartment lodgings, flat paved or concrete surface. Turn the engine off. Operate the parking brake.
Most vehicles are nowadays equipped with "Imitation" rotors, and the Dodge Dakota is one of them.
Instructions
Remove Dodge Dakota Brake Rotors
2. Put a spin chock at the end one of the rear tires.
3. Hole the lug nuts loose on both front tires using the breaking bar and a socket. Tear them loose only--do not loosen them very yet or remove them.
4. Lift the Motor lorry with the floor jack and position the jack stands under the front frame rails in a defended fashion. Provided you're removing both rotors To possess them machined, lift both sides of the Motor lorry and upgrade the front axle. Whether you're removing the rotors to change them, lift one side at a date and then switch to the other.
5. Remove the lug nuts and turn.
6. Remove the caliper bolts with the ratchet and a socket.
7. Pry the caliper off the rotor with the exorbitant screwdriver and hang the caliper to the chassis with the bungee cord. Determine not own the caliper to hang by its brake hose. In some Dakota models, the pads are clipped to the caliper and cause not require to be removed until you compress the caliper piston. On other Dakota models, the pads Testament latest on the caliper bridge and can be gently pried gone with the screwdriver. When you remove the pads, accept note how they came off in order to reinstall them the same way.
8. Remove the retainer rings (if present) on the hub of the rotor around two of the studs. Cut them off with the pair of dikes because you do not need these rings when you replace the rotors.
9. Remove the rotor. It may be rusted, stuck to the hub. If you're replacing the rotor, simply shock the rotor from the hub by striking it with a hammer. If you're removing the rotors to be machined or to reuse them, shock them with a heavy rubber mallet instead.
10. Replace the rotor by reversing the procedure. Compress the piston with a C-clamp. Pump the foot pedal 5 or 6 times to restore the hydraulic pressure back to the caliper piston. Failure to do so could result in danger. Tighten the lug nuts using an adjustable torque wrench set to the correct torque specifications for your particular Dodge Dakota, which you can get from the owner's manual.
