Although Toyota installed the 1.6L engine for their 1990 Toyota Corolla, they came absent with contrary mould versions. This method that in most cases, you can accretion access to the failed starter motor in your Corolla for replacement. Nevertheless getting the starter gone on the 4A-GE engine replica is a amassed involved capacity. Much, this repair activity is within the skills of most Corolla owners. Jack up your Corolla with a floor jack blameless Sufficiently for you to crawl and grind underneath the engine. Help the vehicle with a couple of jack stands and block the rear wheels with two wooden blocks.4. Predispose under your Toyota and remove the engine under covers with a ratchet and socket, provided you are working on the 4A-GE engine.
Select off the bad (murky) battery cable with a wrench and produce confident it is secured out from accidentally touching the battery proclaim. This Testament avoid creating a short method and bad electric parts as you remove the starter.
2. Remove the air cleaner meeting from the top of the engine to accumulation access to the starter Engine from above the engine compartment. End a Phillips-head screwdriver. This is the meeting that contains the air filter.
3. And without the duty for earmarked tools, you can expect to pin money the starter in your driveway in approximately two to three hours.
Instructions
Removing the Starter Motor
1.Also, remove the front exhaust pipe, which connects to the exhaust manifold, and the electric cooling fan assembly, using the ratchet, short ratchet extension and socket.
5. Detach the electrical wire and cable from the back of the starter solenoid with a wrench. This is the smaller cylinder mounted on the starter motor.
6. Loosen the starter mounting bolts with a ratchet and socket. Reach the lower mounting bolt from under the vehicle. Remove the upper mounting bolt and then get under the car. Hold the starter firmly with one hand. Finish removing the lower mounting bolt and take the starter out of the vehicle.
Installing the Starter Motor
7. Get under the vehicle and position the new starter in place. Hold it firmly with one hand, aligning the bottom mounting hold on the starter with the mounting hole on the transmission bell housing and start the bottom mounting bolt but do not tighten it yet. Start the upper mounting bolt as well and then tighten the bolts to 29 foot-pounds (39 Nm) with a torque wrench and a socket.
8. Reconnect the electrical wire and cable to the back of the solenoid with the wrench.
9. Replace the electric cooling fan assembly, front exhaust pipe and engine under covers using the ratchet, short ratchet extension and socket, if you are working on the 4A-GE engine.
10. Lower your Corolla off the jack stands and remove the wooden blocks from the rear wheels.
11. Replace the air cleaner assembly with the Phillips-head screwdriver.
12. Reconnect the negative (black) battery cable with the wrench.
