The Honda CR-V is equipped with anti-lock CD brakes that thirst for general perpetuation to operate properly. Honda recommends replacing the brake pads every 50,000 miles, while the brake rotors thirst for less frequent avail. Test the rotors for damage from the brake pad wear indicators. Blaze scoring on the rotor's surface can be resurfaced to a smooth illumination. Ponderous gouging warrants rotor replacement as soon as viable. You can choose To possess your Honda's brakes replaced by a Expert or you can cause it yourself.
Instructions
Remove the clamp or pliers once the piston is fully depressed.7. Apply brake grease to the inside of the caliper. Procedure to the front of the vehicle and up thrust the hood. Remove the cap from the crackerjack cylinder located to the fly of the Honda's engine. Siphon half of the brake fluid from the reservoir with a syringe or turkey baster. Settle a shop rag over the container to garner debris from the remaining fluid.
2. Loosen the lug nuts on the wheels similar to the brakes you Testament be replacing, with the tire iron included in the Honda rotate concervation apparatus. Lift the CR-V and rest the frame on at least two jack stands. Remove the lug nuts and obtain the wheels off.
3. Pull the retaining clips from the absent of the brake caliper with a span of needle-nose pliers. Adjust message of the means the clips fit into the caliper for coming reinsertion. Remove the two caliper slide bolts with the wrench. Lift the caliper from the brake meeting and suspend it above the trundle hub with a bungee cord.
4. Slide the brake pads from the sides of the caliper. The pads are constant to the caliper by metal clips that may demand some prying with a Apartment lodgings screwdriver to remove them. Remove the rotor pin (or screw) with a #3 Phillips-head screwdriver. The pin is located on the centre chop of the CD rotor, called the "top-hat" cut. Pull the rotor straight from the rotate hub.
5. Remove the packaging from the dewy rotors and Disinfected the discs thoroughly with a cloth towel and brake parts cleaner. Slide the contemporary CD onto the revolve bolts with the top-hat divide facing outward. Modify the rotor pin with the screwdriver.
6. Situate the C-clamp or channel lock pliers over the caliper piston and the back side of the caliper wall. Squeeze the piston into the side of the caliper until it is flush with the inside of the caliper's side. The caliper piston forces the brake pads against the rotor. You need to open it To admit for the thicker pads and rotor.1. Grounds the CR-V on a Apartment lodgings stretch of means or driveway and use the parking brake. Pull the hood Proceeds lever, located under the dashboard on the Chauffeur's side.
Slide the new brake pads onto the sides of the caliper. Place the caliper over the rotor and screw in the caliper pins with the wrench. Replace the retaining clip on the outside of the caliper by hand.
8. Place the wheels back onto the wheel bolts and screw on the lug nuts by hand. Lift the Honda with the jack to remove the jack stands, then lower the tires to the ground. Tighten the lug nuts with the tire iron.
9. Repeat Steps 2 through 8 for each additional sets of brakes that require replacement.
10. Return to the engine compartment. Remove the shop rag and place a funnel inside the master cylinder. Fill the reservoir with brake fluid and replace the cap. Close the hood.
