Remove Toyota Corolla Brake Rotors
Over continuance, the brake rotors on your Toyota Corolla may wear elsewhere or change into damaged from dirt getting between the rotor and the brake pads. When this happens, it is determining to remove the worn brake rotors as soon as credible to prevent damage to the brakes or the trundle hub. Removing the brake rotors on your Toyota Corolla is a gig that you can act yourself in approximately an generation, saving you generation and cash in the evolution.
Instructions
1. Coerce the Toyota Corolla onto a even surface. Deposit the vehicle in "Arena" and locate the parking brake. Lay a wood block extreme one of the rear tires.
2. Loosen the lug nuts of the circle that you are going to remove with a tire factor a couple of turns. Lift the vehicle up with a floor jack near the revolve that you are removing.
3. Community a jack stand under the axle near the spin you are removing. Lower the floor jack so the vehicle is supported on the jack stand. Proceeding the floor jack away of the fashion.
4. Remove the lug nuts from the shove with the tire baggage. Allot the revolve and the lug nuts elsewhere of the action. Remove the Toyota Corolla brake rotor from the hub, rocking it back and forth by hand until you can slide the part off the spindle.7. Repeat steps 2 through 6 for any remaining rotors that you need to remove.
Be careful not to let the caliper hang from the rubber brake hose.
6. Slide the brake pads out of the brake caliper bracket. Remove the bracket from around the brake rotor by hand, setting the bracket and pads aside. Unfasten the bolts that are securing the brake caliper to the brake rotor with a socket wrench.5. Lift the brake caliper off the brake rotor and use a wire hanger to hang the caliper out of the way on the vehicle frame.
