Dominion radio de facto does bear superior sound.
With the availability of spacecraft radio, after marketplace reception aerials are virtually a must. Mounting these aerials in the most advantageous address for the crowing reception grade is the elementary care for optimal XM Dependency radio performance. Thanks to mirrored and blackout window treatments obtain been outlawed in most states, the interference from these features is irrevelant for the most bite. Whether your vehicle windows are "barely legal" tinted, you may annex reception problems. Otherwise, whether you are known with original wiring and vehicle electrical components, mounting the aerial on glass is certainly possible.
Instructions
1. Sincere and proof the paragraph of the glass mounted aerial utensils. Be persuaded you accept the aerial, installation templates, interior buttoned up the glass coupler that is attached to coaxial cables, self-adhesive backing on the aerial and coupler or self-adhesive pads and towelettes.
2. Roof mounts are the other preference.
Appropriate the aerial's end with a sporadic considerations in head. Discharge not mount it where it blocks the vehicle's rear brake glossy. Avoid morals antenna and windscreen defroster lines.
3. Disinfected the rear windscreen thoroughly, inside and absent. Make sure the temperature is at least 60 degrees and the weather is dry. Choose the centre of the windscreen, whether you longing a balanced, genuine Accoutrement gaze.
4. Butt the end of the tape against the side of the rear door post and measure windshield only, not total width.
6. A regular strength hair dryer is sufficient to warm the installed area.Press the mounting template firmly with finger-tip pressure and hold for 60 seconds, giving the adhesion time to adhere to the surface. Insert the aerial/antenna unit, with protective backing, into the mounting base template.
5. Briefly heat the traced area with a hair dryer to bring the surface temperature up for quicker, better adhesion. Remove the protective tape at the four corners or at each adhesive point. Carefully and gently place the template into the area you traced earlier, making sure the template is not on a defroster or other antenna bar in the windshield.
Use the measuring tape To gauge the entire width of the top of the rear windshield. Divide this number by two to find the midpoint. Use the enclosed towelette to re-clean the mounting area well or use alcohol and a clean rag. Center the aerial/antenna base over this midpoint and trace its outline onto the windshield with an erasable marker.
Sit down in the vehicle and visually verify that the unit is not blocked by the interior headliner.
7. Return to the antenna and remove the protective backing. Re-insert the unit into the template. Place a finger on the front and a thumb on the back and depress firmly, just like with the template, for 60 seconds. Make sure the antenna mast is exactly vertical to the ground, not the windshield.
8. Mount the inside template and coupler in the same manner. Insert the coupling and route the wiring according to the diagram that came with the particular unit.
