The Kia Spectra is a compact van produced from 2000 to 2009. The moment hour of this series includes the 2004 over 2009 models, and represents a greater redesign over the fundamental period Kia. The one shot engine available for the 2005 Kia in North American is a four-cylinder 2.0-liter engine with a dual overhead camshaft. This draft uses a timing cestuses to manage the camshafts with the crankshaft. The most chief tool of replacing the timing girth is attention the crankshaft and camshafts in the true position during the procedure.
Instructions
1. Install the timing belt tensioner with a socket wrench. Place the new timing belt onto the crankshaft sprocket, idler pulley, camshaft sprockets and timing belt tensioner thanks to order.4.
2. Turn the crankshaft pulley clockwise to affiliate the groove on the pulley with the timing site on the lower timing belt insert. Disconnect the pulley and flange for the crankshaft with a socket wrench. Remove the lower timing band embrace and timing region tensioner. Detach the timing cummerbund from the pulleys.
3. Turn the crankshaft clockwise to range the timing marks for the crankshaft and camshaft. Disconnect the cable from the con battery terminal with a socket wrench to make certain you don't inadvertently set off the engine. Lift the vehicle and back it on jack stands. Remove the engine encompass, true revolve and side comprehend for the genuine rotate. Detach the frill ride belts, drench pump pulley and upper comprehend for the timing girdle.
Turn the timing belt tensioner clockwise to apply tension to the timing belt. Press the tension side of the timing belt with moderate force. The tension is correct when the deflection of the timing belt is about 0.2 in. Tighten the mounting bolts for the tensioner to 20 ft. lbs. with a torque wrench. Turn the crankshaft clockwise by two full turns and align the timing marks once again.
5. Attach the lower timing belt cover and tighten its mounting bolts to between six and seven ft. lbs. with a torque wrench. Connect the flange and pulley for the crankshaft. Tighten the bolt for the crankshaft pulley to between 123 and 130 ft. lbs. Connect the upper timing belt cover and tighten the mounting bolts to between six and seven ft. lbs.
6. Install the water pump pulley and accessory drive belts with a socket wrench. Attach the right wheel and side cover for the right wheel. Replace the engine cover and connect the cable to the negative battery terminal with a socket wrench.
