Change an Alternator in a Montero Sport
Without the capacity from the alternator, your ignition course Testament acquire to depend on the battery for electrical faculty. Whether the alternator is not working, the battery Testament fail genuine quickly and the vehivle Testament blockade running. Whether you suspect that the alternator in your Montero Sport is not working properly, you can transform it or remove it and keep it tested; most Car parts stores Testament evaluation the alternator for you at liberty whether you bring it in.
Instructions
1. Remove the contravening battery cable from the battery with a wrench. Assign the cable aside and allot the alternator on the front of the engine.
2. Remove the adjusting bolt at the top of the alternator with a wrench or socket and ratchet. Loosen the lower mounting bolt and push the alternator toward the engine to loosen the cestuses. Remove the girdle from the alternator.
Position the cutting edge alternator in community and install the lower mounting bolt. Concession the bolt loose.5.
3. Place the wiring harness connections on the rear of the alternator. (There are two of them, a bell connector on the "B" terminal and a plug in connector.) Remove the call connector, using a wrench, then unplug the moment connector by pushing the locking tabs on the connector and pulling it free lunch of the alternator.4. Remove the mounting bolts from the alternator with a socket and ratchet, then lift the alternator absent of the engine compartment.
Install the upper adjusting bolt and leave it loose. Attach the two wiring harness connections on the rear of the alternator, then tighten the bolt on the ring connector with a wrench. Ensure that the second connector is secure.
6. Slide the drive belt onto the alternator pulley and pull the alternator out away from the engine. Tighten the adjusting bolt with a wrench once the belt is tight. Tighten the lower mounting bolt with a socket and ratchet.
7. Install the negative battery cable on the negative post of the battery and tighten the bolt with a wrench or socket and ratchet. Start the engine and verify that the belt is correctly running over the pulleys. Check to see that the alternator is charging further.
